No. 1717 INSTRUCTIONS FOR ASSEMBLING THE INFANTRY EQUIPMENT MODEL OF 1910 ELEVEN FIGURES MARCH 11, 1912 WASHINGTON GOVERNMENT PRINTING OFFICE 1917 ~7 F No. 1717 INSTRUCTIONS FOR ASSEMBLING THE INFANTRY EQUIPMENT MODEL OF 1910 ELEVEN FIGURES MARCH 11, 1912 WAR DEPARTMENT, OFFICE OF THE CHIEF OF ORDNANCE, Washington, March 11, 1912. This Manual is published for the information and government of the Regular Army and Organized Militia of the United States. By order of the Secretary of War: WILLIAM CROZIEB, Brigadier General, Chief of Ordnance. 3 100953 17 INSTRUCTIONS FOR ASSEMBLING THE INFANTRY EQUIPMENT, MODEL OF 1910. 1. The Cartridge Belt. (a) To assemble the belt. Place the adjusting strap on the ground, eyeleted edge to the front: place the pocket sections on the ground in prolongation of the adjusting strap, pockets down, tops of pockets to the front; insert end of adjusting strap in outer loop of metal guide, from the upper side, carry it under the middle bar and up through the inner loop; engage the wire hook on the end of adjusting strap in the eyelets provided on the inner surface of the belt. (b) To adjust the belt. Adjust the belt to fit loosely about the waist i. e., so that when buckled it may rest well down over the hip bones on the sides of the body and below the pit of the abdomen in front. Care should be taken that the adjustment be made equally from both ends of the adjusting strap, so that the center eyelet will be in the middle of the belt. (c) To fill the belt. Unsnap the flap of the pocket and the interior retaining strap; lay the retaining strap out flat in prolongation of the pocket, insert a clip of cartridges, points of bullets up, in front of the retaining strap : press down until the base of the clip rests on the bottom of the pocket: pass the retaining strap over the bullet points and fasten it to the outside of the pocket by means of the fastener provided; insert a second clip of cartridges, points of bullets down, in rear of the first clip : press down until the points of the bullets rest on the bottom of the pocket : close the flap of the pocket and fasten by means of the fastener provided. The remaining nine pockets are filled in like manner. 2. To Attach the First-aid Pouch: Attach the pouch under the second pocket of the right section of the belt by inserting one hook of the double-hook attachment in the eyelet from the inside of the belt ; pinch the base of the pocket, bring- ing eyelets close together, and insert the other hook in the same manner in the adjoining eyelet. 5 6 ASSEMBLING INFANTRY EQUIPMENT, MODEL OF 1910. Place the first-aid packet in the pouch and secure the cover. S. To Attach the Canteen Cover: Attach the canteen cover to the belt under the rear pocket of the right section in the same manner as the first-aid pouch. Place the canteen and cup (assembled) in the cover and secure the flaps. 4. To Attach the Pack Carrier to the Haversack : Spread the haversack on the ground, inner side down, outer flap to the front (fig. 4) ; place the buttonholed edge of the pack carrier on the buttonholed edge of the haversack, lettered side of carrier up; buttonholes of carrier superimposed upon the corresponding ones of the haversack ; lace the carrier to the haversack by passing the ends of the coupling strap down through the corresponding buttonholes of the carrier and haversack nearest the center of the carrier, bring- ing the ends up through the next buttonholes and continuing to the right and left, respectively, to the sides. 5. To Attach the Cartridge Belt to the Haversack: Place the haversack and pack carrier (assembled) on the ground, inner side down (fig. 5) ; place the cartridge belt, pockets down, tops to the front, along the junction of the haversack and carrier; insert hook on rear belt suspender in the center eyelet of the adjusting strap, so that the end of the hook will be on the outside of the belt ; insert hooks on ends of front belt suspenders in the eyelets between the second and third pockets from the outer ends of the belt, so that the end of the hooks will be on the outside of the belt. 6. To Attach the Bayonet Scabbard to the Haversack: Attach the scabbard by passing its lower end through the loop provided on the side of the haversack body, then engage the double- hook attachment in the eyelets on the outer flap on the haversack, inserting the hooks from the inside. Place the bayonet in the scabbard. 7. To Attach the Intrenching Tool Carrier to the Haversack: Fold the outer flap of the haversack over so that the meat-can pouch is uppermost : pass the intrenching tool carrier underneath the meat-can pouch and engage the double-hook attachment in the eye- lets in the flap provided, inserting the hooks from the underside. Place the intrenching tool in the carrier and secure. Place the meat can. knife, fork, and spoon in the meat-can pouch. The equipment is now assembled and is never disassembled except to detach the pack carrier and its contents as hereinafter provided for. ASSEMBLING INFANTRY EQUIPMENT, MODEL OF 1910. TO ASSEMBLE THE FULL EQUIPMENT. RATIONS.) Place the assembled equipment on the ground, suspender side of haversack down, pockets of cartridge belt up, haversack spread out, inside flap and pack carrier extended their full length to the rear (fig. 6). Place three cartons of hard bread in the center of the haversack body, the lower one on the line of attachment of the inside flap ; lay the remaining carton of hard bread, the condiment can and the bacon can on the top of these, the condiment can and the bacon can at the bottom, top of the bacon can to the front ; the socks and toilet articles are rolled, towel on the outside, into a bundle of the same approxi- mate dimensions as a carton of hard bread, and are placed in front of the two rows thus formed. The inside flap of the haversack is folded over these articles, the end of the flap being turned in so that the flap, thus shortened, extends about 2 inches beyond the top of the upper row ; the sides of the haver- sack are folded over the sides of the rows ; the upper binding straps are passed through the loops on the outside of the inside flap, each strap through the loop opposite the point of its attachment to the haversack body, and fastened by means of the buckle on the opposite side, the strap being passed through the opening in the buckle next to its attachment, over the center bar, and back through the opening of the buckle away from its attachment : the strap is pulled tight to make the fastening secure: the outer flap of the haversack is folded over and fastened by means of the lower haversack binding strap and the buckle on the inside of the outer flap; the strap is pulled tight, draw- ing the outer flap snugly over the filled haversack. The haversack is now packed and the carrier is ready for the recep- tion of the pack (fig. 7). If one haversack ration and one emergency ration are carried in lieu of two haversack rations, the haversack is packed in the manner described above, except that two cartons of hard bread and the bacon can form the bottom layer, the bacon can on the bottom: the condi- ment can, the emergency ration, and the toilet articles form the top layer. If one emergency ration is carried in addition to the two haversack rations, it is packed on top of the top layer. To make the Pack (fig. 8) : Spread the shelter half on the ground and fold in the triangular ends, forming an approximate square from the half, the guy on the inside : fold the poncho once across its shortest dimension, then twice across its longest dimension, and lay it in the center of the shelter 8 ASSEMBLING INFANTRY EQUIPMENT, MODEL OF 1910. half; fold the blanket as described for the poncho and place it on the latter; place the shelter tent pins in the folds of the blanket, in the center and across the shortest dimension; fold the edges of the shelter half snugly over the blanket and poncho and, beginning on either of the short sides, roll tightly and compactly. This forms the pack. To Assemble the Pack (fig. 9) : Place the pack in the pack carrier and grasp the lower suspension rings, one in each hand ; place the right knee against the bottom of the roll; pull the carrier down and force the pack up close against the bottom of the packed haversack; without removing the knee, pass the lower carrier binding strap over the pack and secure it by means of the opposite buckle; in a similar manner secure the lower haversack binding strap and then the upper carrier binding strap. Engage the snap hook on the pack suspenders in the lower sus- pension rings. The equipment is now assembled and packed as prescribed for the full equipment. TO ASSEMBLE THE FULL EQUIPMENT. (WITHOUT RATIONS.) Place the assembled equipment on the ground as heretofore de- scribed; fold up the inside flap of the haversack so that its end will be on a line with the top of the haversack body ; fold up the lower haversack strap in the same manner. To Make up the Pack: Fold the poncho, blanket and shelter half, and make up the pack as heretofore prescribed, except that the condiment and bacon can (the former inside the latter) and the toilet articles and socks are rolled in the pack. In this case the pack is rolled, beginning on either of the long sides instead of the short sides, as heretofore described. To Assemble the Pack: Place the pack on the haversack and pack carrier, its upper end on a line with the upper edge of the haversack body; bind it to the haversack and carrier by means of the haversack and pack binding straps; fold down the outer flap on the haversack and secure it by means of the free end of the middle haversack binding strap and the buckle provided on the underside of the flap ; engage the snap hooks of the. pack suspenders in the lower suspension rings. The equipment is now packed and assembled (fig. 10). To Adjust the Equipment to the Soldier: Put on the equipment, slipping the arms one at a time through the pack suspenders as through the sleeves of a coat: by means of ASSEMBLING INFANTRY EQUIPMENT, MODEL OF 1910. 9 the adjusting buckles on the belt suspenders, raise or lower the belt until it rests well down over the hip bones on the sides and below the pit of the abdomen in front; raise or lower it in rear until the adjusting strap lies smoothly across the small of the back; by means of the adjusting buckles on the pack suspenders, raise or lower the load on the back until the top of the haversack is on a level with the top of the shoulders, the pack suspenders, from their point of attachment to the haversack to the line of tangency with the shoulder, being horizontal. The latter is absolutely essential to the proper adjustment of the load. The position of the belt is the same whether filled or empty. TO ASSEMBLE THE FULL EQUIPMENT LESS THE PACK. (WiTii RATIONS.) (Fig. 11.) Detach the carrier from the haversack ; place the rest of the equip- ment on the ground as heretofore described; place the four cartons of hard bread, the bacon can, the condiment can, and the toilet articles in one row in the middle of the haversack body, the toilet articles at the top, the bacon can at the bottom, top to the front, the row extend- ing from top to bottom of the haversack ; fold the inside flap over the row thus formed ; fold the sides of the haversack up and over ; pass the three haversack binding straps through the loops on the inside flap and secure by means of the buckles on the opposite side of the haversack; pass the lower haversack binding strap through the small buttonhole in the lower edge of the haversack, fold the outer flap of the haversack over the whole and secure by means of the buckle on its underside and the lower haversack binding strap. Pass the haversack suspension rings through the contiguous button- holes in the lower edge of the haversack and engage the snap hooks on the ends of the pack suspenders. If one haversack ration and one emergency ration are carried in lieu of two haversack rations, the haversack is packed in the manner described above, except that one emergenc}^ ration is substituted for two of the cartons of hard bread. If one emergency ration is carried in addition to the two haversack rations, it is packed on top of the layer. TO ASSEMBLE THE FULL EQUIPMENT LESS THE PACK. (WITHOUT RATIONS.) Detach the carrier from the haversack ; place the rest of the equip- ment on the ground as heretofore described; fold up the inside flap of the haversack until its upper end is on a line with the top of the haversack body; fold the sides of the haversack over, pass the three 10 ASSEMBLING INFAXTEY EQUIPMENT, MODEL OF 1910. haversack binding straps through the loops on the inside flap and secure by means of the buckles on the opposite side of the haver- sack; pass the lower haversack binding strap through the small buttonhole in the lower edge of the haversack; place the condiment and bacon can (the former inside the latter) and the toilet articles and socks in the bottom of the pouch thus formed; fold the outer flap of the haversack over the whole and secure by means of the buckle on its underside and the lower haversack binding strap. Pass the haversack suspension rings through the contiguous but- tonholes in the lower edge of the haversack and engage the snap hooks on the ends of the pack suspenders. To Adjust the Equipment to the Soldier: Put on the equipment as prescribed for the full equipment. Ad- just the cartridge belt as prescribed for the full equipment. Adjust the pack suspenders so that the top of the haversack is on a level with the top of the shoulders. TO DISCARD THE PACK WITHOUT REMOVING THE EQUIPMENT FROM THE BODY. Unsnap the pack suspenders from the suspension rings and snap them into the eyelets on top of the belt and in rear of the rear pockets of the right and left pocket sections; support the bottom of the pack with the left hand and with the right hand grasp the coupling strap at its middle and withdraw first one end, then the other; press down gently on the pack with both hands and remove it. When the pack has been removed, lace the coupling strap into the buttonholes along the upper edge of the carrier. Adjust the pack suspenders. WAR DEPARTMENT, OFFICE OF THE CHIEF OF ORDNANCE, Washington, March 11, 1912. FORM No. 1717. Ed. May 2517 5.000. o