key: cord-1027419-jxgcvrhl authors: Choi, Sangchun; Han, Chul; Lee, Jisook; Kim, Sang-Il; Kim, In Byung title: Innovative screening tests for COVID-19 in South Korea date: 2020-04-16 journal: Clin Exp Emerg Med DOI: 10.15441/ceem.20.032 sha: d34c38c86376588d18785608e9bd8dbca98722d0 doc_id: 1027419 cord_uid: jxgcvrhl Recently, the number of Corona Virus Disease 2019 (COVID-19) cases has increased remarkably in South Korea, so the triage clinics and emergency departments (ED) are expected to be overcrowded with patients with presumed infection. As of March 21st, there was a total of 8,799 confirmed cases of COVID-19 and 102 related deaths in South Korea that was one of the top countries with high incidence rates [1]. This sharp increase in infection is associated with 1) outbreaks in individual provinces, 2) deployment of rapid and aggressive screening tests, 3) dedicated healthcare staffs for virus screening tests, 4) quarantine inspection data transparency and accurate data reporting, and 5) public health lessons from previous Severe Acute Respiratory Syndrome (SARS) and Middle East Respiratory Syndrome (MERS) outbreaks. This commentary introduces innovative screening tests that are currently used in South Korea for COVID-19, e.g., Drive-Through and Walk-Through tests, and compare the advantages and disadvantages of both methods. Drive-Through (DT) and Walk-Through (WT) tests are designed to provide a rapid screening, have a minimal risk of infection, and reduce excessive use of medical supplies like personal protective equipment (PPE). 2 The risk of infection may be reduced by limiting the exposure of testees or direct contacts between the testees and healthcare workers. The DT tests are generally conducted in large low-traffic areas, such as public parking or stadium parking lots. 2, 3 On the other hand, the WT tests can be performed in a clean testing booth that can be installed near the hospital. Table 1 shows the pros and cons of DT and WT testing for COVID-19. Testing for COVID-19 can be performed at a drive-through site, as shown in Fig. 1 . The driver/ testee can stay inside his car during the entire process ( < 15 min), consisting of multiple steps: patient registration (3-4 min), medical examination (2 min), specimen collection (2 min), discharge instructions (2 min), and payment for testing service (2 min). Healthcare workers are supposed to wear the level-D PPE that is composed of inner and outer gloves, a gown (hooded coverall), an N95 mask (respirator), goggles (eye shield) or a face shield, and safety shoes or boots. Depending on the required contact level with patients or the availability of medical supply resources, healthcare staff may use PPE after modifying it, following the facility guidelines. 4 • Efficiency -Testing can be completed in about 20 min. • Reduced risk of infection -Disinfection and ventilation of the booth should be done after every use, and it can be done with relative ease. -Healthcare staffs don't make any direct contact with the testees. • Prevent excessive use of medical supplies -The booth walls separate healthcare staff from testees, so the use of medical supplies is reduced. • Reduced workload -The workload for conducting the WT tests is less than the DT tests. • Robustness of method -The booth is installed close or next to the hospital unit, so testing is less likely to be affected by adverse weather conditions. • Test more patients -Testing service is accessible even to non-drivers. -It is possible to test multiple patients at once using more than one clean booth. • Efficiency -Testing can be completed in about 15 min. • Reduced risk of infection -No need for disinfection and ventilation of the booth -Healthcare staffs don't make any direct contact with the testees. • Prevent excessive use of medical supplies -The booth walls separate healthcare staff from testees, so the use of medical supplies is reduced. • Reduced workload -The workload for conducting the WT tests is less than the DT test. • Test more patients -Testing service is accessible even to non-drivers. -It is possible to test multiple patients at once using more than one clean booth. Cons • Medical consumerism -A patient may get tested at multiple testing sites, which can be seen as promoting medical consumerism. • Additionally required supports -Healthcare staffs will benefit from a support person who helps with writing orders and filling out medical records. -The testing site should be in the areas that are less populated but close enough to the hospital for future follow-up. • Worker fatigue -Healthcare staff fatigue due to excessive workload. Working outdoors > 2 hours wearing the high-level PPE can tire the staff to the level of fatigue, so taking frequent breaks is recommended. 6 • Risk of infection -The risk of infection exists related to possible handling errors of samples. -Healthcare staff may lose attention when changing gowns or gloves due to fatigue. • Testing capacity limitations -Non-drivers cannot use the testing service. -Cross-infection may occur between the driver and the passenger, so only one person/driver at a time should be tested per vehicle. • Adverse weather conditions -Adverse weather conditions may complicate outdoors testing. • Cost -The initial cost of the installation of a test site can be relatively high. • Medical consumerism -A patient may get tested at multiple testing sites, which can be seen as promoting medical consumerism. • Risk of infection -The risk of infection exists for the testees while he/she is waiting for the test in a reception area, especially if overcrowded. -The risk of infection exists for healthcare staff for any kind of equipment failures, such as glove tears or perforation. • Medical consumerism -A patient may get tested at multiple testing sites, which can be seen as promoting medical consumerism. • Risk of infection -The risk of infection exists for healthcare staff for any equipment failure, such as when the gloves tear. • Adverse weather conditions -Adverse weather conditions may complicate outdoors testing. Sangchun Choi, et al. Testing for COVID-19 can be performed at a walking-through site, as shown in Fig. 2 . In the WT test using a negative pressure booth, the testee stays inside the disinfected booth, while the healthcare worker is outside the booth, disallowing a direct contact between the two. The clean booth is designed to enclose the testee with transparent walls and a pair of gloves on one wall for healthcare staff to use when collecting patient samples and examining the patient. Before the test, healthcare staff is required to put on the PPE consisting of a pair of gloves, a gown, and a disposable face mask. The PPE can be adjusted to follow the facility guidelines or according to the availability of medical supply resources. The whole testing process, from registration to payment, can be completed in about 20 minutes. The WT test using a positive pressure booth combines the advantages of the DT test and the WT test using a negative pressure booth. The tester stays inside the booth while the testee stays outside; thus, direct contact between the two is avoided (Fig. 3) . The positive pressure booth looks similar to the negative pressure booth. Positive pressure inside the booth is used to prevent contaminants from coming inside the booth. The testing process is similar but shorter (< 10 min) since it is unnecessary to disinfect the booth after each test. Healthcare staff assists the check-in process. Healthcare staff records testee's symptoms, personal information, and epidemiologic association. The staff completes this process using a mobile phone without making contact with the testee. If the testee is suspected of coronavirus infection, his/her samples are collected before he/she gets transferred to a designated hospital. Healthcare staff leans over the open window for naso-and oro-pharyngeal swabs, and then the testee closes his/her car windows to collect his/her sputum specimen. Car ventilation is set at the "recirculation" mode to minimize the risk of infection for healthcare workers. After receiving the samples, the healthcare staff puts on a new vinyl apron and disinfects his/her hands using alcohol-based hand sanitizer. The testee gets the information about how to check the test result and is asked to self-quarantine until further notice regarding the outcome. Instructions are also provided regarding what the testee should do if his/her symptoms get worse. Healthcare staff records testee's symptoms, personal information, and epidemiologic association. The staff can complete this process using a mobile phone or a Personal Computer (PC) system. The testee enters the clean booth once the check-in process is complete. The testee stays inside the negative pressure booth, while the healthcare staff is outside the booth the whole time. The booth was designed with transparent walls, one of which has a pair of long gloves for a healthcare worker to use to make naso-and oro-pharyngeal swabs. The testee collects the sputum sample by himself/herself in the closed booth. The testee then receives information about how to check the test result and how to self-quarantine. Instructions are also provided regarding what the testee should do if his/her symptoms get worse. After the exit of the testee, the booth gets ventilated and disinfected for 2 minutes the first time and 10 minutes after that. Sangchun Choi, et al. Pandemics caused by viruses have tended to break out once every decade or every other decade over the past 300 years. 5 Now, they may be occurring more often and in more variable cycles. Successful management of viral infection and diseases requires quarantine and treatment of those who may have an infection. Thus, early-stage screening tests that are efficient and effective are essential for preventing the virus from spreading widely. Each step of the testing process should be completed quickly and minimize the existing risk of infection for healthcare workers and testees alike, meeting the general safety requirements. In this commentary, we introduce innovative screening testing that has been successfully applied to the COVID-19 outbreak in South Korea. Although the efficacy of the methods should be further clarified, we believe that our experience with a successful implementation of these tests for COVID-19 may apply to other countries. Healthcare staff records testee's symptoms, personal information, and epidemiologic association. The booth is installed in a tent or a container house separated from the hospital. The staff can complete this process using a mobile phone without making contact with the testees. If the testee is suspected of coronavirus infection, his/her samples are collected before he/she gets transferred to a designated hospital. The tester enters into the positive pressure booth and stays inside, while the testee is outside. The booth is designed with transparent walls, one of which has a pair of long gloves for a healthcare worker to use to make naso-and oro-pharyngeal swabs. The testee collects the sputum sample by himself/herself outside the booth. The testee receives the information about how to check the testing result and is asked to self-quarantine until further notice regarding the outcome. Instructions are also provided regarding what the testee should do if his/her symptoms get worse. ?brdId = 1&brdGubun = 13&ncvContSeq = &contS eq = &board_id = &gubun = . Updated 2020 Drive-through medicine: a novel proposal for rapid evaluation of patients during an influenza pandemic Drive-Through Screening Center for COVID-19: a Safe and Efficient Screening System against Massive Community Outbreak. measures Rational use of personal protective equipment for coronavirus disease 2019 (COVID-19). Interim guiance 27 Planning for the next pandemic of influenza Respirator tolerance in health care workers Super-speed Walking Through Test' Came Out