key: cord-0932122-rq0b11ul
authors: Jahromi, Reza; Mogharab, Vahid; Jahromi, Hossein; Avazpour, Arezoo
title: Synergistic effects of anionic surfactants on coronavirus (SARS-CoV-2) virucidal efficiency of sanitizing fluids to fight COVID-19
date: 2020-08-26
journal: Food Chem Toxicol
DOI: 10.1016/j.fct.2020.111702
sha: e9d6fa6efa3224a5b053b239926fa7d30658a213
doc_id: 932122
cord_uid: rq0b11ul

Our surrounding environment, especially often-touched contaminated surfaces, plays an important role in the transmission of pathogens in society. The shortage of effective sanitizing fluids, however, became a global challenge quickly after the coronavirus disease-19 (COVID-19) outbreak in December 2019. In this study, we present the effect of surfactants on coronavirus (SARS-CoV-2) virucidal efficiency in sanitizing fluids. Sodium dodecylbenzenesulfonate (SDBS), sodium laureth sulfate (SLS), and two commercial dish soap and liquid hand soap were studied with the goal of evaporation rate reduction in sanitizing liquids to maximize surface contact time. Twelve fluids with different recipes composed of ethanol, isopropanol, SDBS, SLS, glycerin, and water of standardized hardness (WSH) were tested for their evaporation time and virucidal efficiency. Evaporation time increased by 17-63% when surfactant agents were added to the liquid. In addition, surfactant incorporation enhanced the virucidal efficiency between 15-27% according to the 4-field test in the EN 16615:2015 European Standard method. Most importantly, however, we found that surfactant addition provides a synergistic effect with alcohols to inactivate the SARS-CoV-2 virus. This study provides a simple, yet effective solution to improve the virucidal efficiency of commonly used sanitizers.

The coronavirus pandemic, also known as the COVID-19 pandemic, is an ongoing pandemic of coronavirus disease 2019, caused by severe acute respiratory syndrome coronavirus 2 (SARS CoV 2) (Lu et al., 2020) . To date, more than 4.5 million cases have been confirmed, with more than 300,000 deaths globally. Surfaces can become contaminated by hands, objects, settling of virus-containing aerosols, or contaminated fluids (Núñez-Delgado, 2020; Sattar, 2004) . Therefore, these surfaces may play an important role in the transmission of pathogens in society (Otter et al., 2014; Weber et al., 2010) . Manual disinfection of surfaces by wiping and spraying antibacterial fluids is an important part of the healthcare setting. The shortage of effective sanitizing liquids, however, became a global challenge quickly after the COVID-19 outbreak in December 2019 (Jahromi et al., 2020) . Ethanol and isopropanol are the major active ingredient (~70-80%) of most common sanitizers, but the high volatility of these alcohols makes them less effective when sprayed on surfaces. The alcohol retention time on the surface plays a key role in its viricidal efficiency. A common solution to overcome this challenge is to include less volatile material (such as aloe vera gel) in sanitizer formulation. However, while blended with gels, the final solution becomes thicker and more difficult to spray on surfaces.

Anionic surfactants that are used in the manufacturing of liquid soaps and detergents are also known for their antibacterial efficiency because of their dual functionality. The hydrophobic side of these surfactants can dissolve the outer layer of viruses and bacteria, while the hydrophilic side dissolves in water (Asker et al., 2011; Schwuger, 1973) . Therefore, these agents act as an emulsifier to remove the contamination. After the COVID-19 pandemic, world health organization (WHO) has recommended that individuals wash hands more frequently and at least for 20 seconds to ensure bacterial and virus removal from the skin (Cascella et al., 2020; Everett J o u r n a l P r e -p r o o f et al., 2020) . It has been shown that the outer lipid layer of SARS-CoV-2 disrupts after long enough contact time with anionic surfactants (WHO, 2020) .

In this study, we explored the effect of anionic surfactants in addition to sanitizing liquids with different recipes. The main objective of this study was to reduce the volatility of the sanitizers without negatively influencing their thickness (viscosity) while boosting their virucidal properties. Two well known anionic surfactants, sodium dodecylbenzenesulfonate (SDBS) and sodium laureth sulfate (SLS) that are commonly used in dish soaps and liquid soaps, respectively, were studied at 3% concentration. In addition, commercial dish soap and liquid hand soap were subjected to experimentation with the goal of providing a simple, yet effective solution for daily applications. All tested liquids were also studied for their SARS-CoV-2 viricidal efficiencies.

The SARS-CoV-2 coronavirus was obtained from Molecular Epidemiology Laboratory at Shiraz University of Medical Science, Iran. Ethanol (200 proof), isopropanol (>99%), glycerin (>95%), SDBS (>95%), and SLS (>95%) were obtained from Millipore Sigma (Beijing, China). Two commercial dish soap (active ingredient: C10-16 alkyldimethyl amine oxide, sodium laureth sulfate, methylisothiazolinone, PEG-24 copolymer, sodium laureth sulfate, sodium dodecylbenzenesulfonate, sodium hydroxide, sodium chloride) and hand soap (active ingredient: sodium C12-13 parethsulfate, cocamidopropyl betaine, sodium laureth sulfate, sodium benzoate, sodium salycilate, tetrasodium EDTA, PEG-18 glyceryl oleate, citric acid) were purchased from Golrang (Tehran, Iran). Water of standardized hardness (WSH) was used in control experiments J o u r n a l P r e -p r o o f and also as a diluting agent in the formulation of sanitizing fluids. Twelve sanitizing fluids with different recipes, as shown in Table 1 , were prepared to examine the effect of individual components and mixtures on evaporation rate and SARS-CoV-2 virucidal efficiency of the solutions. Aqueous solutions containing up to 70% low-carbon alcohols (such as ethanol and propanol) have been reported to show promising disinfection efficiency. The fluids used in this study, therefore, contained either 70% ethanol or isopropanol, or a 50/50 (mass ratio) combination of both alcohols. In addition, our preliminary screening experiments (data not provided) suggested that the presence of 1.5-7.0% surfactants in the fluid can improve its virucidal efficiency significantly. As most commercial liquid soaps contain up to 3% of these surfactants, we used equal surfactant concentration in the formulation of our tested fluids.

For evaporation tests, polyvinyl chloride (PVC) material with polyurethane (PUR) surface coating was sliced into 20×50 cm (2 mm thickness) pieces and placed on a flat bench, as shown in Fig. 1 . Sanitizing fluids were sprayed three times (from a distance of ~30 cm from the surface) on the PVC object. Fluid evaporation was recorded using a Sony HXR-NX100 camera, and videos were processed using Ulead Videostudio software. A 60-watt amber light was installed 100 cm above the surface to shine light on the surface to record better resolution videos. The surrounding environment was isolated to eliminate possible air convection, and the room temperature was maintained at ~27 ºC. The exact amount of evaporation time was recorded for each sprayed liquid.

The coronavirus suspension was prepared by infecting monolayers of A549 cell (human lung epithelial carcinoma cells) lines. The virus titers of these suspensions ranged from 10 5 to 10 10 TCID 50 /ml. To determine the virucidal efficiency of each liquid, the 4-field test was performed according to EN 16615:2015 European Standard with slight modification (Nen, 1997) . Briefly, J o u r n a l P r e -p r o o f four squares as test fields were marked on the PVC with PUR surface coating material figuring a row, 5 cm away from each other. The marked test field 1 on this flooring was inoculated with the SARS-CoV-2 virus suspension. 10 μl inoculum was pipetted on the first test field and distributed with a spatula. A granite block was rapidly moved from test field 1 to test field 4 and back within no longer than 5 seconds. After 10 min contact time and drying, the sanitizing fluid was sprayed on the contaminated surface three times and allowed for 1 min. The coronavirus was then recovered from all four fields with a nylon swab. Swabs of each field were transferred to 5 ml Minimum Essential Medium (MEM), respectively, and tubes were vortexed for 120 s. Virus titres were determined by endpoint dilution techniques according to the EN 14476:2015

European Standard and calculated using the method of Kärber and Spearman (Kärber, 1931; Spearman, 1908) . The virus reduction factor (RF) on the test fields was then determined according to the method described in detail by Becker et al. (Becker et al., 2019) . All experiments were carried out in triplicates. S9 S10 S11 S12 

Water-based sanitizing solutions normally consist of ~70% alcohol (ethanol and/or isopropanol) as an active ingredient, ~3% glycerin to reduce dehydration if applied to the skin, and a small amount of fragrance. WSH, tested as control liquid, showed 97 s evaporation time using the method described above. To study the evaporation of sanitizing fluids, individual and multiplecompound tests were performed. Evaporation test results are presented in Fig. 2 . The evaporation time of 70% isopropanol solution (S2) was higher than that of ethanol solution (S1) that was ascribed to a higher molecular weight of isopropanol than ethanol. The effect of glycerin addition to a mixture of 35% ethanol and 35% isopropanol (S3 versus S4 solutions) also showed The twelve liquids exhibited different virucidal efficacies against the chosen coronavirus (Fig.   3 ). Isopropanol showed a slightly higher (~7%) reduction factor than ethanol solution (S1 and S2 in Fig. 3) . However, the combination of the alcohols (S3) did not exhibit RF between S1 and S2.

The virucidal efficiency of S3 was ~13% greater than the expected value (average of S1 and S2) that could be ascribed to a different virucidal activity in S3. The addition of 3% glycerin did not influence the RF significantly as can be seen from the RF value obtained for S3 (6.2) versus S4 . Fluids S8 and S9 were prepared to examine the influence of real dish soap and hand soap on RF value. Interestingly, we observed higher virucidal efficiency in the case of commercial soaps. The RF increased by ~15% when SLS was replaced with liquid hand soap (S7 versus S8). Moreover, the recorded RF for the fluid with 3% dish soap (S9) was ~16% greater than the one with 3% SDBS (S5). The excellent increase in both evaporation time and virucidal efficiency in the presence of the tested anionic surfactants and liquid soaps clearly suggested a synergistic effect between alcohols, surfactants, and virucidal activity mechanisms. Because the combination of the two alcohols (S3) demonstrated higher RF than individual alcohols (S1 and S2), only fluid S3 was tested for virucidal property in the presence of glycerin. However, the addition of dish soap to solution S4 caused a significant increase in RF by ~27% from 6 to 7.6.

This result was in contrast with the former observation when the addition of 3% glycerin caused a slight decrease in fluid S4 compared with solution S3. Therefore, there could be another positive synergistic effect between the three agents (alcohol, soap, and glycerin) that creates a need for further investigation. We hypothesize that alcohols participate in the virucidal activity by dehydration mechanism, while anionic surfactants inactivate the virus via cell disruption mechanism. This hypothesis, with emphasis on the synergistic influence, will be studied as the next phase of the present investigation. Solutions S11 and S12 were prepared to explore the virucidal properties of the commercial liquid soaps, regardless of alcohols. As expected, although these components slightly increased the RF value, the changes were negligible when compared with the control experiment (WSH protective equipment has also been reported. As such, ionized hydrogen peroxide has been reported to inactivate SARS-CoV-2 completely when applied to N95 respirators (Cheng et al., 2020) . However, considering the ongoing pandemic situation, it is less likely for governments and policymakers to be able to make such solutions available to the public. In view of the mentioned advantages of the present study, the influence of other surfactants on SARS-CoV-2

inactivation has yet to be explored. In addition, more detailed studies are needed to investigate possible negative effects of long term exposure to such anionic surfactants used in this work.

The 

Formation and stabilization of antimicrobial delivery systems based on electrostatic complexes of cationic− non-ionic mixed micelles and anionic polysaccharides

Evaluation of the virucidal efficacy of disinfectant wipes with a test method simulating practical conditions

Features, evaluation and treatment coronavirus (COVID-19)

Disinfection of N95 respirators by ionized hydrogen peroxide during pandemic coronavirus disease 2019 (COVID-19) due to SARS-CoV-2

The effectiveness of moral messages on public health behavioral intentions during the COVID-19 pandemic

Inactivation of surrogate coronaviruses on hard surfaces by health care germicides

COVID-19 with positive bronchoalveolar lavage fluid but negative nasopharyngeal and oropharyngeal swabs: A case report and insights

Beitrag zur kollektiven Behandlung pharmakologischer Reihenversuche. Archive for experimental Pathology and Pharmacology

Outbreak of pneumonia of unknown etiology in Wuhan, China: The mystery and the miracle

Chemical disinfectants and antisepticsquantitative suspension test for the evaluation of bactericidal activity of chemical disinfectants and antiseptics used in food, industrial, domestic, and institutional areas-test method and requirements (phase 1). European committee for standardization

What do we know about the SARS-CoV-2 coronavirus in the environment

World Health Organization, 2020. Considerations for quarantine of individuals in the context of containment for coronavirus disease ( COVID-19) : interim guidance

WHO/2019-nCov/IHR_Quarantine/2020.1). World Health Organization

The role of contaminated surfaces in the transmission of nosocomial pathogens. Use of biocidal surfaces for reduction of healthcare acquired infections

Efficacy of various disinfectants against SARS coronavirus

Microbicides and the environmental control of nosocomial viral infections

Mechanism of interaction between ionic surfactants and polyglycol ethers in water

The method of right and wrong cases (constant stimuli) without Gauss's formulae

Role of hospital surfaces in the transmission of emerging health care-associated pathogens: norovirus, Clostridium difficile, and Acinetobacter species

The experimental works for this study were carried out at Jahrom University of Medical Sciences, Iran, as part of the rapid response act to the COVID-19. No human and/or animals were subjected to experimentation during this study.

J o u r n a l P r e -p r o o f

☒ The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper.☐The authors declare the following financial interests/personal relationships which may be considered as potential competing interests:J o u r n a l P r e -p r o o f