key: cord-0740231-oy9znosz authors: Martín, Gabriel; Rojo-Alba, Susana; Castelló-Abietar, Cristian; Abreu-Salinas, Fátima; Costales, Isabel; Boga, Jose Antonio; Melón, Santiago; Álvarez-Argüelles, Marta Elena title: Comparison of in-house SARS-CoV-2 genome extraction procedures. A need for COVID-19 pandemic date: 2021-12-10 journal: J Virol Methods DOI: 10.1016/j.jviromet.2021.114415 sha: d366e9a51902d685189268c9f48926ab2f1087b6 doc_id: 740231 cord_uid: oy9znosz Among the methods used to diagnose COVID-19, those based on genomic detection by q(RT)-PCR are the most sensitive. To perform these assays, a previous genome extraction of the sample is required. The dramatic increase in the number of SARS-CoV-2 detection assays has increased the demand for extraction reagents hindering the supply of commercial reagents. Homemade reagents and procedures could be an alternative. Nasopharyngeal samples were extracted by seven different methods as well as the automatic method MagNaPure96, to detect SARS-CoV-2. All protocols show sensitivity higher than 87%, in comparison with reference method, for detecting SARS-CoV-2 as well as human β- globin. Our results support that these procedures, using common and cheap reagents, are effective to extract RNA (from SARS-CoV-2) or DNA (from human β-globin) genome from nasopharyngeal swabs. Furthermore, these procedures could be easily adopted by routine diagnostic laboratories to implement detection methods to help to fight against COVID-19 pandemic. In December 2019, Chinese health authorities identified the new betacoronavirus SARS-CoV-2 as the cause of the respiratory illness COVID-19, which was declared pandemic by World Health Organization in January 2020 (1, 2) . High sensitivity diagnostic methods to detect and contain potential outbreaks are required to fight against this pandemic. Among these methods, those based on genomic detection by quantitative retrotranscriptase (RT)-PCR have been proved to be the best for a quick and sensitive detection of COVID-19 infected patients. To perform these assays, a previous genome extraction of the sample is required. This step is essential since both quantity and quality of the genome obtained could affect the further amplification process (3). Because of that, some studies comparing different commercial and/or manual procedures for genome extraction from different type of samples, such as fecal, blood or respiratory specimens have been reported (4-6). The current global health emergency due to SARS-CoV-2 pandemic has caused a dramatic increase in the number of detection assays performed by diagnostic laboratories and, therefore, a huge demand for extraction reagents making difficult the supply of commercial reagents. Homemade reagents and manual procedures are an alternative. Our team has conducted a comparative study between seven manual procedures with commercial and homemade reagents. The aim was to evaluate alternative protocols to commercial genome extraction procedures to be used for SARS-CoV-2 detection by routine diagnostic laboratories. Samples: A total of 58 nasopharyngeal samples from patients with suspicious of SARS-CoV-2 infection were collected. The original volume of each sample (200 µL) was diluted 8 times to a final volume of 1.6 mL to get enough volume to perform all extraction procedures. From this final volume, 200µL were used for each extraction procedure. The automatic extraction method MagNa Pure 96 System (Roche, Ginebra, Switzerland), which is usually developed in the laboratory, was taken as reference. Seven different procedures were carried out manually. MagNA Pure 96 System and MagNA Pure 32 System (Roche) were performed using commercial reagents following manufacturer´s instructions. Other four protocols named as One- Step Method A (OSM-A), One-Step Method B (OSM-B), Two-Step Method (TSM) and "Bikop" method, were performed using common homemade reagents. For these protocols slight changes were established for the lysis reagents. For OSM-A and Bikop, lysis was made with guanidyl isocyanate (GIT), sarcosyl and sodium citrate, while for OSM-B it was made with GIT, SDS, Tris and EDTA. For TSM, first lysis step was made with SDS, Tris and EDTA and second lysis step was the same as for OSM-A and Bikop. Proteinase K (pK) was added in all lysis steps with GIT. For wash buffers, first was isopropanol, second was ethanol and third was a NaCl solution. All reagent concentrations and how were they used are specified on table 1. The last protocol, which is based on heat treatment was performed in a SureCycler 8800 (Agilent Technologies, Santa Clara, CA) and no reagents were necessary. Protocols and reagents of the different genome extraction procedures were tested one time for each sample. Table 2) . Amplification and subsequent analysis were carried out using the Applied Biosystems 7500 Real-time PCR System (Applied Biosystems). The cycling protocol was as follows: (50ºC, 20 min; 95ºC, 5 min; 45 cycles of 95ºC, 10 sec; 55ºC, 15 sec and 60ºC, 30 sec). A T-Student test, whose null hypothesis was that in-house protocols works in the same way that the reference method, with a p-value of 0.05, was performed. The sensitivity for β-globin detection of the manual methods was also calculated by comparison to automatic method. For "Bikop" extraction sensitivity was 87.9% while for OSM-A reached 100%. The limits of 95% CI were 30.16 and 32.38 in automatic method MP96. By mean difference, in "Bikop" extraction they were 34.53 and 36.25 and in MP32 they were 35.96 and 37.58. The expansion of the outbreak of the new coronavirus SARS-CoV-2 and the global pandemic situation caused by its spread has provoked the need of a quick and efficient tool for diagnosis of viral disease. Genome amplification based on PCR has been raised as the best method and as important as the amplification process is the previous genome extraction step. In this process, the viral genome as well as cellular genome is purified. Both genomes are used to amplify and quantify the viral genome and the J o u r n a l P r e -p r o o f 6 human gene β-globin, respectively. The ratio between the two values allows calculating a normalized viral load and determining the sample quality (8, 9). Considering that the use of PCR commercial kits is very usual in most clinical laboratories, the supply of reagents during pandemic peak was a common problem. Trying to obtain a solution for future similar situations, several extraction genome procedures were tested with the idea of obtaining a method to be included in manual or even automatic diagnostic procedures used routinely in clinical laboratories. Similar methods were also developed by other authors (10-12). In our study, the sensitivity for SARS-CoV-2 of the tested procedures was higher than 93%. These results were also observed in β-globin gene amplification, were all methods bowed sensitivity higher than 87%. According these data, any method has enough sensitivity and can be used routinely in a clinical laboratory. Data were a little bit worse when Cts of SARS-CoV-2 were compared with reference methods, Also, higher Cts were observed in β-globin detection. Because sensitivity was decreased in both targets (SARS-CoV-2 and β-globin), viral load was minimally underestimated, no more than 0.5 log considering that each 3 Cts means a difference in the viral load of 1 log. A possible explanation to these results is that manual processing is less precise and more prone to error than automatic methods using a robot. Automatization of these procedures can solve this situation. One limitation of the tested procedures can be that they are not quick enough. A possible alternative is cut time at least in half for washing steps. In preliminary studies in our laboratory changes in results were not observed. The main advantage is the use of common reagents making possible these procedures can be easily adapted by any other laboratory directly or changing the reagents for other with similar properties. Furthermore, these procedures could also be used for the extraction of RNA or DNA genome of other viruses. Heat extraction method, whose sensitivities for SARS-CoV-2 and β-globin were 96.7% and 87.9%, respectively, can be used for a quick screening of patients under suspicion of infection by SARS-CoV-2. Recent reports using a similar method support the viability of this technology to SARS-CoV-2 genome extraction (13, 14) . Considering that this is the quickest (only 15 minutes), cheapest and easiest (only need a thermoblock) protocol of all the tested procedures, it appears as a clear alternative to be implemented in small diagnostic laboratories, favoring a decentralization of SARS-CoV-2 diagnostic and desaturating central hospitals. In this method, Cts were similar than in others, and good enough for using when samples level is high. It should be noted that only 5µL of sample were used, in this method, half, in proportion, of that used in the other procedures. That could be the answer to that sensitivity is a little bit lower. In summary, in-house procedures evaluated can substitute commercial techniques performing a successful SARS-CoV-2 genome extraction using common and cheap reagents. On the other hand, human genome can also be successfully extracted allowing the use of β-globin gene as sample quality control and for normalized viral load calculus. These procedures could be easily adopted by clinical laboratories and be used to extract human samples with suspect of any viral presence. It is worth to note that Heat extraction is a quick, cheap, and easy diagnostic method, which could be used in small diagnosis laboratories. J o u r n a l P r e -p r o o f A novel coronavirus outbreak of global health concern To ASCOL (Asturiana de Control Lechero) for partially financing this project, supporting research as the key to overcoming the pandemic.